Zavig D3100 Guide d'installation télécharger pdf (Page 6)

b. Wall mounting and Ceiling mounting

1) Attached the drill template to the wall. Drill three holes into the wall, which two for screws and one for cable

(if you want to route cables through conduit hole). Then hammer the supplied plastic anchors into the screw

holes and secure the plate with supplied screws.

2) Align the three holes on the base of camera with the two plastic anchors on the wall or ceiling, insert the

supplied screws to the corresponding hole and screw them.

3) Adjust the angle of camera to aim the shooting area.

Note:

When using this device, please use an Ethernet cable without the strain relief boot.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Zavig D3100 Guide d'installation Page 6